IEC61109 Distribution 33kV Insulators Flexible High Performance
Dimensions and Characteristics of 35kV(33kV)composite Suspension Insulator
|Figure. No||Model||Rated Voltage||Specified Mechanical Load||Coupling Size||Section Length||Minimum Creepage||Full-Wave Impulse Withstand Voltage (Peak)|
1 Min Wet Power Frequency Withstand Voltage
|Weight (for Reference)|
1, 33kV high tension insulators are widely used in overhead
transmission lines and substations
2, Dead end fittings are up to the requirements from the clients,
usually we use ball, socket, tongue, clevis for tension insulators
with forged steel or cast steel. The dimensions and coupling size
can be exactly according to the specification requirements from the
3, The silicon rubber color of the insulators are also up to the
requirements from the clients and all the silicon rubber materials
past 5000 hours aging test silicon content test and hydrophobicity
4, ECR core rods are used in all the insulators, so we can
guarantee a very good mechanical strength and anti-acid pollution
performance for the insulators.
5, All our insulators were type tested and design tested in
accordance with IEC61109, maximum RIV is 100µV when tested at 1MHz
and10% over nominal line ground voltage for indicated system
6, All the 33kV tension suspension insulators are without corona
1, 33kV overhead transmission power lines.
2, 33kV substations
3, 33kV distribution lines
1, Very good anti-pollution performance, no need to wash the
insulators after the installation in lines.
2, Very convenient installation because of its light weight and one
whole piece compared with glass insulators and ceramic insulators.
3, Excellent hydrophobicity characteristics can help to void
flashover and guarantee the insulators with very good electric